Aileron problem makes yoke usable

BRUNNER Forum Forums Products CLSE-Yoke Aileron problem makes yoke usable

This topic contains 2 replies, has 3 voices, and was last updated by  camrad 2 weeks, 5 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #822

    arndt777
    Participant

    When I am switching on the yoke and init it, the handle is turning to the right and staying there. It requires a lot of force to turn in the middle, turning it to the complete left is impossible. When switching off the yoke, the handle is still remaining on the complete right side, and it still requires a lot of force to move it to the left. When I remove the power cable, the handle is relaxing. But when I connect it again to power, the same game is starting again. So the yoke right now is unusable.
    My version of the CLS-Software is 4.9.1, the version of the yoke’s firmware is 354.
    What can I do to resolve the problem?
    Kind regards
    Arndt

    #823

    sbrunner
    Keymaster

    The problem has been resolved by an update to v358 and loading default values

    Regards

    Stefan Brunner

    #1117

    camrad
    Participant

    Where is the firmware V358? I have the same problem, but yoke turning violently left and right if moved aileron

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk