Any way to get the S-tec autopilot to control individual axes?

BRUNNER Forum Forums Software CLS2SIM Software Flight Simulation Software X-PLANE 9/10/11 Any way to get the S-tec autopilot to control individual axes?

This topic contains 0 replies, has 1 voice, and was last updated by  tigrrrlily 1 month, 1 week ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #2356

    tigrrrlily
    Participant

    I’m flying the 172 REP and the behaviors of the altitude hold, heading and vertical speed modes on the autopilot all basically act the same in that they take control of both axes. Am I doing something wrong? I’d like to not develop any bad habits; are there any plans to get individual autopilot control of the different axes working? Thanks.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk