CLSE-MKII yoke buttons do not work after firmware update

BRUNNER Forum Forums Products CLSE-Yoke CLSE-MKII yoke buttons do not work after firmware update

Tagged: 

This topic contains 0 replies, has 1 voice, and was last updated by  johnrutoski 1 month, 1 week ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #2030

    johnrutoski
    Participant

    I have a dual yoke CLS-EMKII yoke and rudder system and have upgraded the firmware to V473 and I am using the CLS software version 4.27.1. after the upgrade the when installing the new CLS software it only detected one yoke and rudder combo but I have two yokes and two rudders connected to a E2can ethernet connection. The buttons worked with the old firmware and older CLS software. I know I probably should not have upgraded them but I went ahead and did it. Now the number of buttons are less and I have a hat switch on each yoke and they do not show up either.

    Any help would be greatly appreciated.

    John

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk