Engine Vibration Effect

BRUNNER Forum Forums Products CLSE-Yoke Engine Vibration Effect

This topic contains 2 replies, has 2 voices, and was last updated by  tzangetsu 1 week, 2 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #1482

    tzangetsu
    Participant

    Does the CLS-E yoke (not NG version) support the vibration effect?

    I have the pedals and they do have it. And from some CLS-E NG reviews I’ve seen, that yoke also has engine vibration effects supported. But I cannot get it too work on my CLS-Eyoke. Not sure if it hat yoke just doesn’t support them, or if I need some kind of firmware update.

    #1484

    sbrunner
    Keymaster

    Hi

    The CLS-E Yoke also supports vibration effects
    see here on hoe to Setup
    https://cls2sim.brunner-innovation.swiss/CLSProfileManager.htm#effects
    Regards
    Stefan Brunner

    #1493

    tzangetsu
    Participant

    Thanks Stefan, I played around with those settings, the vibration seems so muted compared to the CLS-E pedal vibrations. I had to disconnect the pedals just to feel anything from the yoke. Even at 100% force, it’s barely there. I haven’t experienced the vibration on the CLS-E NG, so I can’t compare. But if I were to put number on the vibration based on feel, I’d say (pedals: 100%, yoke:5-7%). Is that normal?

    It would also be nice to have two checkboxes that control which axis have engine vibrations enabled, similar to the stick shaker options.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk