External trim device.

BRUNNER Forum Forums Products CLSE-Yoke External trim device.

This topic contains 2 replies, has 3 voices, and was last updated by  soenke 4 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #2133

    ropp29
    Participant

    Hello, I have a CLS-E Mk II, using the “hardware trim” option in MFS 2020. I have a USB Cessna-style trim control that I would like to use. Is there a way to use this with “hardware trim”? I.e., is there a way to make an external analog input control trim?

    #2138

    guido
    Participant

    Hi Ropp29,

    I asked this very question recently (note I use Xplane 11). The answer was

    ‘Have Trim wheel plugged in, and FIRST start CLS2Sim, only afterwards start the sim.

    Don’t map the trim wheel in the simulation. In CLS2Sim profile manager you must see the trim wheel.

    Leave as is and instead go to CLS2Sim > Profile Manager > Trim tab.

    Enable: YES

    Velocity: Have to experiment for each plane. Lower if movement too jerky.

    Movement: Leave at 100% ! Important !

    User external trim : NO

    Trim Compensation: NO

    Use Hardware trim: NO’

    I hope this helps?

    Regards,

    Guy

    #2173

    soenke
    Participant

    @ropp29: Was that successful? I’m wondering as I’m also using external trim wheel, but so far did not try to set it up in CLS2Sim.

    @brunner: Couldn’t CLS2Sim read out the simulator’s trim setting (or even just the force on the elevator?) to make the right pitch position and force?

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk