Firmware update failed (CLSE NG)

BRUNNER Forum › Forums › Products › CLSE-Yoke › Firmware update failed (CLSE NG)

This topic contains 0 replies, has 1 voice, and was last updated by  aurel42 1 year, 10 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 22. November 2021 at 22:21 #2598

    aurel42
    Participant

    When updating the firmware of my CLSE NG yoke, I get the message “Update failed: couldn’t load defaults” on node 2.
    Node 1 reports “Successfully loaded defaults”.
    The message in the center of the window (above the green arrow) says “Update Successful”.

    I’ve tried repeating the update, the results were the same.

    Do I need to worry, or can I ignore the error message?

  • Author
    Posts
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

support(at)brunner-innovation.swiss

Help-Desk
Tickets