How to you disable Button #1 and stop Trim switch from moving yoke?

BRUNNER Forum Forums Products CLSE-Yoke How to you disable Button #1 and stop Trim switch from moving yoke?

This topic contains 3 replies, has 3 voices, and was last updated by  sbrunner 6 months, 2 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #2422

    yoveldelrio
    Participant

    Hi all,

    Sorry if this sounds confusing, but when using the Brunner Yoke with FS2020, I noticed that the trim switch moves the yoke even when the trim switch is to “Not Bound” under Buttons. I also noticed that pressing the Button #1 on the yoke resets the trim and abruptly moves the yoke, even though Button #1 is not bound.

    How do I resolve this issue, if it is possible?

    Thanks!

    #2423

    webmaximus
    Participant

    Could it be because you have hardware trim enabled?

    #2424

    yoveldelrio
    Participant

    I tried with that disabled, unfortunately it did not seem to make a difference.

    #2425

    sbrunner
    Keymaster

    Hi
    Open a ticket we will send you a firmware update
    Regards

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk