Need community help for CLS-E yoke please!!

BRUNNER Forum Forums Products CLSE-Yoke Need community help for CLS-E yoke please!!

This topic contains 2 replies, has 2 voices, and was last updated by  jake 5 months, 3 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #2101


    Hello Everyone,
    I have switched to MSFS2020 and removed P3D from my sim. MSFS does not recognize the yoke when making control assignments. I had no problem with keyboard, mouse, throttle and the Crosswind pedals. However the yoke kept the rocker switch assignments that i used in P3D: left rocker for elevator trim, right rocker for flaps. I have not been able to assign any buttons at all and this is a big problem for me. Can someone tell me how to do that? I am sure there must be a way.

    I have sent emails to Brunner twice over the last 2-3 weeks and no reply at all from them. I like the force-feed yoke and it works well using the C172 with the default setting; but if I cannot get the button assignments made i might revert to my old Saitek yoke.

    Thanks and i hope to hear from some experts!



    Hi Jake, this happens because the you can assign functions both in the CLS2Sim Software by Brunner (under Profile Manager > Buttons) and FSFS2020. Had the same issue reassigning the radio call button to the first ATC button in MSFS kept wondering why it’s still messing with my autopilot – same thing, single button triggered both the command assigned in CLS2Sim and the one assigned in MSFS.

    Just pick which software you prefer the make the assignment in, and remove all assignments in the other.



    Many thanks bruno! I will give that a try, sounds simple enough. I did not understand the profile manager and buttons function. Take care, greetings from N. Carolina!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.


Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019