Prepar3d – How to make work

BRUNNER Forum Forums Software CLS2SIM Software Prepar3d – How to make work

This topic contains 0 replies, has 1 voice, and was last updated by  severniae 1 month ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #2044

    severniae
    Participant

    Has anyone had any luck making Prepar3d work well with the Brunner CLS-E yoke?

    As a test I’ve tried the PMDG DC-6 – I can fly reasonably well using hardware trim, forces feel ok. BUT as I get to the upper or lower ends of the speed range, I either lose down elevator authority or up elevator authority. This seems to be because the P3D trim is staying central and for some reason full elevator isn’t available unless trim is set correspondingly.

    So I tried software trim using brunner recommended settings – it just doesn’t work..It also messes up the autopilot.

    Does anyone have any reccomendation?

    Thanks,
    James

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk