Profile Request- CLS-E NG FF / P3d / Aerosoft(Digital Aviation) CRJ Pro

BRUNNER Forum Forums Software CLS2SIM Software Profile Request- CLS-E NG FF / P3d / Aerosoft(Digital Aviation) CRJ Pro

This topic contains 4 replies, has 2 voices, and was last updated by  jazzjw 5 months, 2 weeks ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #1659

    jazzjw
    Participant

    Hello!

    I have tried to configure a profile for Aerosoft(Digital Aviation) CRJ Pro but not successful for weeks.
    I only suspect it is something about elev trim system because CRJ series have automatic trim system(no physical spinning elev trim wheel).
    When I activate Autopilot, it disengages itself very soon, especially when vertical movement is involved.

    Could anyone upload a profile for this or any hint or clue?
    Hmm… I really want to make both work together.

    Thank you!

    #1660

    jovabra
    Participant

    Hi,
    I have no problem with the Aerosoft CRJ pro. Yester on the route of EHAM – EGGL and in very bad weather,a lot of wind (Ciara). On FL 240 wind 260degr/100 kts and I didn’t have any unwanted AP disconnect. The yoke follows the AP without any problem.
    Regards
    Jo va Bra
    My profile is in the Brunner profile cloud

    #1668

    jazzjw
    Participant

    Thank you for sharing your experience.
    I’m just checking… I assume you did ‘connect’ the yoke with P3D?
    You know, on the CLS2Sim, hardware section-connect/init and simulation section-connect… you did all these right?

    And… I have NG model fyi.

    #1669

    jovabra
    Participant

    Yes i did.
    Success

    #1685

    jazzjw
    Participant

    After test and test, I learned things.
    But I can’t make the yoke follow the roll control(swing left/right) still.
    Anyone? any hint?

    fyi,

    Prepar3d v4.5 hot fix 2,
    Fsuipc v5,
    CLS E NG yoke,
    Aerosoft(Digital Aviation) CRJ Profesional

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk