programming yoke buttons in Xplane11

BRUNNER Forum Forums Products CLS-E Rudder programming yoke buttons in Xplane11

This topic contains 1 reply, has 2 voices, and was last updated by  rashadwell 5 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #1344

    mushtaq
    Participant

    Hello Every one
    i just started to use the brunner CLS-E yoke and i am pleased with it but i can not assign any yoke buttons within the Xplane11 joystick calibration i can see the virtual joystick in the controls column but when i try to calibrate it nothing happens i can assign the buttons in profile manager with no problems but i would like to assign some buttons on yoke for plug ins can some one guide me in right directions please i will be gratfull
    TIA
    Mushtaq

    #2121

    rashadwell
    Participant

    if you want to use xplane 11 to program the buttons, then you must un-assign the buttons using the brunner buttons tab. Once they are un-assigned xplane will “see” the buttons and you will be able to assign them. I use a combo of brunner software and xplane software. So for example, button number 1 is assigned using xplane as contact atc. In the brunner software I have button 1 un assigned. Button 2 is trim down in brunner software. Xplane does not recognize button 2. However, the command of trim down does work, because brunner is telling xplane about button 2.

    Hope this helps.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk