Remove and Rotate Yoke 180 degrees

BRUNNER Forum Forums Products CLSE-Yoke Remove and Rotate Yoke 180 degrees

This topic contains 7 replies, has 3 voices, and was last updated by  thedazman 1 year, 5 months ago.

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #681

    learthur
    Participant

    I have mounted my Yoke under the table. Therefore I must rotate the yoke handle 180 degrees to achieve normal operation.

    What is the procedure for reconfiguring the yoke handle 180 degrees in lateral rotation?

    Thanks!

    Lee

    Attachments:
    You must be logged in to view attached files.
    #710

    rashadwell
    Participant

    I have this same situation.

    #711

    learthur
    Participant

    Aluminum angle was my mounting solution.

    #712

    learthur
    Participant

    Here is a photo.

    Attachments:
    You must be logged in to view attached files.
    #714

    rashadwell
    Participant

    Thank you for the fast response. How did you take the cover off?

    #715

    learthur
    Participant

    Remove 2 screws on each side. 8 total

    #808

    thedazman
    Participant

    Is there an official solution to this without invalidating the warranty ?

    ie taking the handle off and turning ?

    Regards Daren

    #809

    thedazman
    Participant

    Seems there isn’t 🙁

    In the end I just mounted it underneath using long screws through the existing holes and left a small gap using tap washers, which reduces temps an additional 5 degrees.

    Daz
    http://Www.fipgauges.com

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk