Scaling Force by H-Stab position..how can we accomplish this?

BRUNNER Forum Forums Products CLSE-Yoke Scaling Force by H-Stab position..how can we accomplish this?

This topic contains 5 replies, has 2 voices, and was last updated by  jovabra 3 months, 1 week ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #2766

    sluflyer06
    Participant

    Hello,

    I’m hoping there is a way to accomplish this, I’m wanting to simulated the Bombardier pitch feel system for the Challenger, to put it simply Bombardier applies varying resistance on the yoke with relationship to the horizontal stabilizer position. How could I accomplish this with my CLS-E mk2?

    Thank You,

    Anthony

    #2767

    jovabra
    Participant

    Hi,
    Did you read the update Hot Start CL650 v1.6.1 Update!

    If you have a force-feedback yoke with controllable force intensity
    (such as a Brunner FFB yoke), you can disable the trim-dependent pitch
    feel in the User Settings under the User Interface tab. You can then
    replicate it in a proper FFB way by gradually increasing the force
    needed to move the elevator as elevator trim goes from 5.0 to 1.25
    (5=lighest, 1.25=heaviest). Outside of this range, the force should be
    constant, as the real pitch feel mechanism doesn’t change force
    intensity outside of these ranges either

    #2768

    sluflyer06
    Participant

    but to do that you need to be able to control force in the Brunner in relation to trim position, not airspeed. Are you saying you know how to do that?

    #2769

    jovabra
    Participant

    Hi,
    For H position signal feedback you need information from the “Hot Start” designers how to deal with it in combination with the Brunner software. It is better
    to contact direct to the Brunner helpdesk en the Hot Start designer.

    #2770

    sluflyer06
    Participant

    I can get the dataref for it, but how to apply this in the Brunner driver/plugin? It’s not a matter on IF the hstab position data is available, that is not a problem, we’ve already discussed this with Hot Start, so now where can i plug that data in, that is the question.

    #2771

    jovabra
    Participant

    Best is not to postthe question on this forum. This is a user to user forum. Send your inquiry for more information to the attention of
    d.buergin@brunner-innovation.swiss
    He is the software secialist.

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk