TBM Profile for NG Yoke

BRUNNER Forum Forums Products CLSE-Yoke TBM Profile for NG Yoke

This topic contains 3 replies, has 4 voices, and was last updated by  mrscott 9 months, 2 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #1371

    r2500
    Participant

    I have a new NG yoke and want a profile for the TBM 900. There is one labeled “TBM _900_Hot_Start_V2” but it is for the CLS-E yoke, not the NG. As a result, I can’t use CLS2SIM to read it. But all of the settings in it are going to be correct for the NG yoke as well, aside from the scaling required to reflect the different force and torque values. Is there a way for me to learn what’s in the profile?

    #1382

    captain737
    Participant

    I have the exact same question regarding the zibo 737 profile!

    #1473

    blaser
    Participant

    I suggest to interpolate the values taking into consideration that the CLS-E offers 100 Nm and 5 NM in pitch and roll respectively. Do the calculations for the NG based on its strength. You will end up with the same profile adapted to the lesser force of the NG.

    Not sure if this makes sense…

    #1524

    mrscott
    Participant

    Blaser / Max,

    How has this issue been resolved? Given the “E” and “NG” are different (Shorter throw and less force – NG), it makes sense the Profiles would be unique to each product. My question is how different do they feel in X-Plane. Has anyone done a side by side comparison?

    Scott

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk