The cls e sticker Z axle calibration problem with VPC ALPHA

BRUNNER Forum Forums Products CLS-E Joystick The cls e sticker Z axle calibration problem with VPC ALPHA

This topic contains 2 replies, has 2 voices, and was last updated by  freyae3 2 weeks, 6 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #2949

    freyae3
    Participant

    I have update the cls-e V631 firmware with VPC sticker.When I calibration the Z axle.The turn left current pos is 19054.The right current pos is19728.The center current pos is 20404.The old firmware does not have this problem.When I change the sitck mode with VPC alpha prima .The Z axle calibration works good.But the buttons work worng.When I slowly turn the stick Z axle from left to center.The current pos change from 19054 to 18440 when near the center position the current pos jump to 20402.When I slowly turn it from right to center the current pos change from 19716 to 20402.

    #2950

    sbrunner
    Keymaster

    Open a ticket we will send you new firmware for test
    Regards

    #2951

    freyae3
    Participant

    Hello please send to my email:ferrari4111@126.com
    Regards

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk