Turn yoke handles 180?

BRUNNER Forum Forums Products CLSE-Yoke Turn yoke handles 180?

This topic contains 0 replies, has 1 voice, and was last updated by  eklynx 2 weeks, 3 days ago.

Viewing 1 post (of 1 total)
  • Author
  • #3035


    I’m trying to figure out the best way how to mount the -NG yoke under my desk. Before i take a screwdriver to the screws holing the actual yoke ‘handles’ on, i’m wondering if anyone’s tried or has thoughts on just taking it off and turning it 180 (so it’s ‘upside down’)? roll is all still the same direction and pitch it still in and out. My concerns that I could think of would be if a) the yoke doesn’t actually lock on upside down, b) the wires for the buttons are too tight to allow doing this, or c) the attachment is just pressure so finding the neutral position again would be a complete pain.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.


Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019