USING CLSE MK. 2 YOKE WITH Elite XTS

BRUNNER Forum Forums Products CLSE-Yoke USING CLSE MK. 2 YOKE WITH Elite XTS

This topic contains 4 replies, has 2 voices, and was last updated by  eliteflyer 2 months, 2 weeks ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #2468

    eliteflyer
    Participant

    Hi.

    Just wondering if anyone is using the above yoke with XTS?
    I have a problem that Elite are finding difficult.
    The yoke works fine but when I turn on AP and I mean just AP no heading, nav etc the yoke and plane start to oscillate side to side. It does this also when heading nav, proc alt are selected as well.
    It follows the commands fine but that oscillation side to side is unacceptable.

    Mark H

    #2599

    eliteflyer
    Participant

    Now resolved by Elite.

    #2801

    simops
    Participant

    Hi Eliteflyer,

    Can you share how it was fixed?

    Thanks

    #2805

    eliteflyer
    Participant

    Hi.

    Of course. Very simple really. Although the Yoke calibrates itself on start up, cery visually going throygh full motion movements, using XTS this is not enough and every aircraft has to be calibrated utilising theie inbuilt calibration system.
    This also has to be repeated reasonably regular to ensure it remains in calibration.
    I found that every aircraft on first use has to be calibrated.

    Hope this helos.

    Eliteflyer

    #2806

    eliteflyer
    Participant

    Apologies for typos!!!😊😊

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk