using the cls-e joystick as a h pattern shifter

BRUNNER Forum Forums Software CLS2SIM Software using the cls-e joystick as a h pattern shifter

This topic contains 1 reply, has 2 voices, and was last updated by  twitchyrudder 8 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #2566

    dragn09
    Participant

    hi, did someone at brunner already think about using the joystick as a shifter?
    the gears could use a low ffb strength and where there isnt one it could be set to 100% to simulate the “lanes” to the gear activation 🙂

    #2583

    twitchyrudder
    Participant

    I was screwing about with the forces and managed to end up with a profile somewhat like a shifter, however assigning it properly is the next challenge…

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk