Xtreme Prototype's GLJ Model LearJet – Trimming issue.

BRUNNER Forum Forums Products CLSE-Yoke Xtreme Prototype's GLJ Model LearJet – Trimming issue.

This topic contains 0 replies, has 1 voice, and was last updated by  bilk 4 months, 2 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #932

    bilk
    Participant

    Hi.
    Is anyone flying the above aircraft in P3Dv4 using the CLSE-Yoke?
    This is a great simulation of this aircraft, but I am having no success in getting realistic trim operation using either the ‘Software’ method or ‘Hardware’ method. The yoke works OK as in conventional mode, but this is not realistic. I have had no problems with a large range of other GA aircraft.
    I would appreciate hearing of other’s experience.
    Regards,
    Bill

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk