Yoke not moving in AP mode

BRUNNER Forum Forums Products CLSE-Yoke Yoke not moving in AP mode

This topic contains 3 replies, has 3 voices, and was last updated by  Diego Bürgin 3 years ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #491

    japmaco
    Participant

    My yoke is not moving when the plane turns etc in AP mode. Also its not possible to abort the AP by moving the yoke by hand like i could do Before.

    Im using the 4.2 version with P3D v4. A2A 172 with Stefans profile from the cloud.
    Firmware is 300.

    NOTE
    Under scale force factor
    … it says AP Inactive…even tho in sim its Active. So im guessing here is where the issues is. The software is not understanding that the AP is ON in the sim and there for not responding and sending signals to the yoke to move.
    Connected via USB

    My settings in ap mode
    – Enhanced AP mode ON
    – On overpower disable AP

    #492

    sbrunner
    Keymaster

    Hi

    You are using a non standard aircraft from A2A.
    Some functions (especially autopilot) doesn’t work with such aircrafts because they are not using the integrated autopilot functions in P3D, FSX…

    Try a standard C172 delivered with P3D, this should work

    Regards

    Stefan Brunner

    #494

    japmaco
    Participant

    I will try, but it worked perfect in v3 with AP. Wierd it just stopped working in V4.
    Ill check it out.

    #496

    Diego Bürgin
    Keymaster

    Hi japmaco

    Can you tell me which CLS2im version you used before?

    Regards

    Diego

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk