Zibo A/P disconnecting again

BRUNNER Forum Forums Software CLS2SIM Software API, Interface control documentation Zibo A/P disconnecting again

This topic contains 0 replies, has 1 voice, and was last updated by  gian19 8 months, 2 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #1530

    gian19
    Participant

    Hi,

    any Zibo user out there having problems with latest release?
    It has been since the latest patches of 3.36 and all 3.37 that I get the A/P disconnects again, especially on approaches when the A/C makes steeper turns and or descents.
    The same behavior we had before both Zibo and Brunner found the solution to make the yoke work with the Zibo mod.
    Off course, “Use Brunner Hardware” is selected in my Avitab. I noticed that if I disconnect the yoke, from the CLS2 interface, during the approach phases the A/P does not disconnect.

    Thanks,
    Gianfranco

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk