sbrunner

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 195 total)
  • Author
    Posts
  • #2873

    sbrunner
    Keymaster

    Just try again

    #2860

    sbrunner
    Keymaster

    Hi
    Download the update v5.1.17
    see notes (We are aware of the dataref deprecation warning.)

    #2718

    sbrunner
    Keymaster

    Hello
    write to support@brunner-innovation.swiss
    Regards

    #2715

    sbrunner
    Keymaster
    #2712

    sbrunner
    Keymaster

    Hi open a ticket in helpdesk
    Regards
    Stefan Brunner

    #2685

    sbrunner
    Keymaster

    Just register with your e-mail again and you will get new password
    https://www.brunner-innovation.swiss/software-download-page/
    only for software and manual downloads
    forum user and password is not affected

    #2611

    sbrunner
    Keymaster

    Hi, sorry but we do not have any ticket from you open a ticket here https://forum.brunner-innovation.swiss/helpdesk/
    and give us more information
    make some screenshots of the button mappings in CLS2Sim and mappings in FS2020

    #2581

    sbrunner
    Keymaster

    Hi you need to connect the Rudder and Yoke over CAN with an RJ45 cable and then connect with one of them over USB to CLS2Sim
    Regards

    #2425

    sbrunner
    Keymaster

    Hi
    Open a ticket we will send you a firmware update
    Regards

    #2419

    sbrunner
    Keymaster

    Hi
    You can enable Auto Connect to simulator under Connection Settings and setup Reconnection Delay
    See also here
    https://cls2sim.brunner-innovation.swiss/SettingsForm.htm
    Regards
    Stefan Brunner

    #2398

    sbrunner
    Keymaster

    Hi
    Open a ticket you will get an firmware update
    Regards
    Stefan Brunner

    #2315

    sbrunner
    Keymaster

    Hello all
    Open a ticket we will send you an update v508 for “Directional Hat + Push dual button press” issue
    We have done a workaround…(the data is trasmitted wrong in the grip)
    Regards
    Stefan Brunner

    #2312

    sbrunner
    Keymaster

    Hi
    Open a ticket with your firmware version, we will check with you
    Regards
    Stefan Brunner

    #2241

    sbrunner
    Keymaster

    Hi all
    We can confirm, USB Rudder issue is fixed since version 1.12.13.0
    Regards
    Stefan Brunner

    #2226

    sbrunner
    Keymaster

    No this is not needed, but it is possible you can switch of the AC Power Lines with an Emergency Circuit (Safety Relais and Stop button)
    We recommend to use a Power strip with a switch, so you can easly power on/off the devices.

Viewing 15 posts - 1 through 15 (of 195 total)

BRUNNER ELEKTRONIK AG

Industriestrasse 27
CH-8335 Hittnau

tel +41 (0)44 953 1010
fax +41 (0)44 953 1019

info(at)brunner-innovation.swiss

Help-Desk